Command and Conquer: Renegade Official Forums: General Discussion

Home » General Discussions » General Discussion » What's the difference between...

Show: Today's Messages :: Polls :: Message Navigator

Re: What's the difference between... [message #430040 is a reply to message #430036]

Fri, 04 June 2010 22:02

snpr1101
Messages: 425
Registered: June 2007
Location: Australia

Karma:

Commander

andr3w282 wrote on Fri, 04 June 2010 23:03

triple post ftw.

I would suggest you hammer your gateway with pings and see if there are drops in the same amount as when you ping websites.

If the drops are high going to your router - it's your wireless/cabling/router thats the problem. If to your router can be proven fine then you can contact your ISP to have them test the path from your house to them - could be bad cabling going to your modem

Ok; ran a few more tests.

http://img52.imageshack.us/img52/9201/pt1mr.jpg

http://img88.imageshack.us/img88/9020/pt2p.jpg

http://img404.imageshack.us/img404/1016/pt3r.jpg

http://img714.imageshack.us/img714/2379/pt4s.jpg

First two tests over 100 hops came back 100%

The second last test I increased the byte size to the maximum setting (32000; the outcome was 3% lost. I don't think it is normal to lose 3% to your own gateway.

Last test is just Wtfmode. Only 8 byte packet size and 70% loss.

Edit: I seem to lose alot more packets with the program than I do with CMD. I average around 6& loss with PingTester and 0% with CMD.

[Updated on: Sat, 05 June 2010 00:30]

Report message to a moderator

[Message index]

		What's the difference between... By: snpr1101 on Fri, 04 June 2010 16:41
		Re: What's the difference between... By: Lone0001 on Fri, 04 June 2010 19:16
		Re: What's the difference between... By: snpr1101 on Fri, 04 June 2010 19:28
		Re: What's the difference between... By: dr3w2 on Fri, 04 June 2010 20:49
		Re: What's the difference between... By: dr3w2 on Fri, 04 June 2010 21:00
		Re: What's the difference between... By: dr3w2 on Fri, 04 June 2010 21:03
		Re: What's the difference between... By: snpr1101 on Fri, 04 June 2010 22:02
		Re: What's the difference between... By: Goztow on Sat, 05 June 2010 00:18
		Re: What's the difference between... By: snpr1101 on Sat, 05 June 2010 00:39
		Re: What's the difference between... By: Goztow on Sat, 05 June 2010 00:40
		Re: What's the difference between... By: dr3w2 on Sat, 05 June 2010 20:11

Previous Topic:	CNCTube - Video Sharing Site
Next Topic:	DCOM Productions

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat May 09 05:47:05 MST 2026

Total time taken to generate the page: 0.00711 seconds