Command and Conquer: Renegade Official Forums: General Discussion

Home » General Discussions » General Discussion » Monitor

Show: Today's Messages :: Polls :: Message Navigator

Re: Monitor [message #365923 is a reply to message #364948]

Sun, 04 January 2009 05:51

danpaul88
Messages: 5795
Registered: June 2004
Location: England

Karma:

General (5 Stars)

If you find the problem is your card can't support 1680x1050@60hz on the DVI output you could maybe swap the monitors over and use a DVI->VGA adapter for the VGA screen so you can plug it into the DVI port (assuming it's a lower resolution) and plug the T220 into the VGA port.

http://steamsignature.com/card/1/76561197975867233.png

Report message to a moderator

[Message index]

		Monitor By: dr3w2 on Fri, 26 December 2008 20:43
		Re: Monitor By: IronWarrior on Sat, 27 December 2008 05:30
		Re: Monitor By: Caveman on Sat, 27 December 2008 06:02
		Re: Monitor By: dr3w2 on Sat, 27 December 2008 22:01
		Re: Monitor By: luv2pb on Sat, 27 December 2008 23:40
		Re: Monitor By: dr3w2 on Sun, 28 December 2008 11:43
		Re: Monitor By: dr3w2 on Fri, 02 January 2009 23:16
		Re: Monitor By: Muad Dib15 on Sat, 03 January 2009 08:09
		Re: Monitor By: CarrierII on Sun, 04 January 2009 12:35
		Re: Monitor By: dr3w2 on Sun, 04 January 2009 13:19
		Re: Monitor By: danpaul88 on Sat, 03 January 2009 08:36
		Re: Monitor By: dr3w2 on Sun, 04 January 2009 00:18
		Re: Monitor By: danpaul88 on Sun, 04 January 2009 05:51

Previous Topic:	<2009>
Next Topic:	Hello

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon May 25 03:04:13 MST 2026

Total time taken to generate the page: 0.00813 seconds