Command and Conquer: Renegade Official Forums: Mod Forum

Home » Renegade Discussions » Mod Forum » Max 8 issues.

Show: Today's Messages :: Polls :: Message Navigator

Re: Max 8 issues. [message #295024 is a reply to message #295021]

Mon, 05 November 2007 15:32

Jerad2142
Messages: 3828
Registered: July 2006
Location: USA

Karma:

General (3 Stars)

One Winged Angel wrote on Mon, 05 November 2007 15:19

Jerad Gray wrote on Mon, 05 November 2007 19:47

The Merovingian wrote on Mon, 05 November 2007 04:17

No Max = No Apoc Rising. Dont Get It

Sometimes you just have to take a step back to RenX, it works fine.

But not if you want to get things back into 3ds Max after working on them in RenX. The mesh collapses when w3d is imported which results in a total mesh re-face job. Not nice.

Use a converter to convert it from max to .3ds.

Visit Jerad's deer sweat shop

Report message to a moderator

[Message index]

		Max 8 issues. By: Zion on Mon, 05 November 2007 04:17
		Re: Max 8 issues. By: zeratul2400 on Mon, 05 November 2007 04:45
		Re: Max 8 issues. By: Zion on Mon, 05 November 2007 05:49
		Re: Max 8 issues. By: Oblivion165 on Mon, 05 November 2007 08:54
		Re: Max 8 issues. By: Jerad2142 on Mon, 05 November 2007 12:47
		Re: Max 8 issues. By: OWA on Mon, 05 November 2007 15:19
		Re: Max 8 issues. By: Jerad2142 on Mon, 05 November 2007 15:32
		Re: Max 8 issues. By: Oblivion165 on Mon, 05 November 2007 15:33
		Re: Max 8 issues. By: Zion on Mon, 05 November 2007 17:44

Previous Topic:	FPS Banana
Next Topic:	Skinning help.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 08 18:26:00 MST 2026

Total time taken to generate the page: 0.00744 seconds