Command and Conquer: Renegade Official Forums: RenGuard Servers » What UDP/TCP ports are used when the !rg command is invoked?

Home » Archived Forums » RenGuard Servers » What UDP/TCP ports are used when the !rg command is invoked?

Show: Today's Messages :: Polls :: Message Navigator

Re: What UDP/TCP ports are used when the !rg command is invoked? [message #218123 is a reply to message #218099]

Fri, 08 September 2006 15:50

Nightma12
Messages: 2599
Registered: August 2003

Karma:

General (2 Stars)
Category Moderator

can the bot connect to the RG network when it loads?

if it can, then u dont need to open any other ports

you should need to open any ports now that i think about it.. as its just an outbound connect to the servserv

Report message to a moderator

[Message index]

		What UDP/TCP ports are used when the !rg command is invoked? By: tonyrolm on Fri, 08 September 2006 14:26
		Re: What UDP/TCP ports are used when the !rg command is invoked? By: Nightma12 on Fri, 08 September 2006 15:50
		Re: What UDP/TCP ports are used when the !rg command is invoked? By: tonyrolm on Fri, 08 September 2006 17:32
		Re: What UDP/TCP ports are used when the !rg command is invoked? By: EvilWhiteDragon on Sat, 09 September 2006 05:22
		Re: What UDP/TCP ports are used when the !rg command is invoked? By: tonyrolm on Sat, 21 April 2007 13:35
		Re: What UDP/TCP ports are used when the !rg command is invoked? By: mac on Thu, 26 April 2007 00:11

Previous Topic:	NR logs Potential ren bypass
Next Topic:	Renguard server help

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Feb 06 00:58:44 MST 2026

Total time taken to generate the page: 0.00661 seconds