Renegade Public Forums
C&C: Renegade --> Dying since 2003™, resurrected in 2024!
Home » Renegade Discussions » Mod Forum » A question about lights
Re: A question about lights [message #459248 is a reply to message #459241] Fri, 11 November 2011 18:08 Go to previous messageGo to previous message
Mauler
Messages: 448
Registered: May 2003
Location: Alberta, Canada
Karma:
Commander
You can try this method to make the lights on your lift.

http://i.imgur.com/00IjV.jpg
Create a cone or cylinder. Apply the texture setting as follows,

Vertex Material Tab
Set Ambient,Diffuse,Specular to black and Emissive to whatever color you wish to emit
- Apply Linear Offset with,
UPerSec=0.02
VPerSec=0.03

Shader Tab
- Blend Mode
'Add'

Texture Tab
- Stage 0 Texture
I used Ref_Dust.tga for this



http://i.imgur.com/X1hrH.jpg
Apply the texture to your cone and use your desired UV coordinates. Now apply a vertex paint modifier to your light mesh.
Now select the bottom vertices of your light cone and apply the black vertex paint. This will help blend your edge and make it look like the light is fading out from its light source. Make sure the mesh has '2-Sided' applied under W3D Tab.


http://i.imgur.com/5kkEc.jpg
There, once your done it will look like this.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: HexEditor / ByteChange
Next Topic: Need some testers & assistance ...
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue May 13 06:32:53 MST 2025

Total time taken to generate the page: 0.01055 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 420.69.
Copyright ©2001-2023 FUDforum Bulletin Board Software