Command and Conquer: Renegade Official Forums: Mod Forum » scaling to exact measurements (Renx)

Home » Renegade Discussions » Mod Forum » scaling to exact measurements (Renx)

Show: Today's Messages :: Polls :: Message Navigator

scaling to exact measurements (Renx) [message #326068]

Sun, 13 April 2008 01:10

Gen_Blacky
Messages: 3250
Registered: September 2006

Karma: 1

General (3 Stars)

So basically I had scaled down a piece of mesh i was working on and then i found something wrong with it. I want to scale the new fixed mesh to exactly the same size old broken mesh was. How do i do this ?

http://s18.postimage.org/jc6qbn4k9/bricks3.png

Report message to a moderator

Re: scaling to exact measurements (Renx) [message #326070 is a reply to message #326068]

Sun, 13 April 2008 02:26

danpaul88
Messages: 5795
Registered: June 2004
Location: England

Karma: 0

General (5 Stars)

You can't, scaling is based on changing it to be a % of the existing size. Your best bet would be to get it as close as possible with trial and error and then manually move some of the vertices to the correct location if they are slightly out.

http://steamsignature.com/card/1/76561197975867233.png

Report message to a moderator

Re: scaling to exact measurements (Renx) [message #326107 is a reply to message #326068]

Sun, 13 April 2008 13:12

Muad Dib15
Messages: 839
Registered: July 2007
Location: behind a computer screen,...

Karma: 0

Colonel

I have that problem with one of my models. I decided to merge it onto one of my maps to see how out of proportion it was, and it took up half the field.

The manliest post on the internet

Report message to a moderator

Previous Topic:	Texture Rotation of Treads (Tank-Tracks)
Next Topic:	Speech Lip Syncing

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Sep 20 16:07:55 MST 2025

Total time taken to generate the page: 0.00589 seconds